2
Carefully unpack screen and remove outer wrapping from
case.
Remove the black tape from the slat bar after the case has
been installed.
There are three ways to install the Designer Contour
®
Electrol
®
with built-in Infrared Remote: Wall Mount, Ceiling Mount, or
Ceiling Hook. Procedures for each method are as follows:
Wall Mount
1. Secure the wall mount bracket to the wall at the desired
height. Bracket should be fastened to wall studs or
some reinforcement within the wall. Concrete or brick
walls require special fasteners and anchors.
2. Make sure the bracket is level. See figure 1 for
reference dimensions.
3. Keep in mind you will need at least 5/8" between the
ceiling and the top of the wall mount bracket to be able
to position the case on the bracket.
4. Mount the screen case on the wall bracket as shown in
figure 1. Be sure the case is fully seated on the bracket.
Tighten the stop screws against the wall bracket.
Ceiling Mount
1. Do not remove the wall mount bracket, even if you are
not using it for mounting. This provides structural
stability to the case.
2. Be sure the ceiling has adequate reinforcement to
attach the screen brackets.
3. The top of the screen case has a channel that the ceiling
mount brackets slide into. Remove the end cap on the
right end of the case and insert the brackets into the
case channel. Lock the brackets in place by tightening
two set screws. Refer to figure 2. Mount can not be
more than 12" from end of case.
4. Hold the screen case up to the ceiling and mark the hole
locations. Drill holes into the ceiling and attach screen
with the appropriate fasteners for your ceiling.
Ceiling Hook
1. Do not remove the wall mount bracket, even if you are
not using it for mounting. This provides structural
stability to the case.
2. Be sure the ceiling has adequate reinforcement to
attach a hook anchor.
3. The top of the screen case has a channel that the ceiling
hook brackets slide into. Remove the end cap on the
right end of the case and insert the brackets into the
case channel. Lock the brackets in place by tightening
two set screws. Refer to figure 3.
4. The brackets can be attached anywhere within 12" of
the end of the case.
5. Attach an S-hook or similar fastener to the large center
hole on the bracket.
INSTALLATION
SET SCREWS (2)
HooK MounT
HoLE
CEILIng
MounT
HoLES
SET SCREWS (2)
FIGURE 2
FIGURE 3
FIGURE 1
4-1/4"
5/16"
9/16"
CASE HooK
WALL
MounT
BRACKET
4-5/8"
SToP SCREW
EnDCAP
EnDCAP
SCREWS
(3)
EnDCAP
EnDCAP
SCREWS
(3)