background image

INSTALLATION

The Deluxe Model B must be suspended from
the ceiling or used with extension type wall
brackets to allow room for the Automatic
Tensionizer.

FOR WALL MOUNTING

Special extension wall 
brackets such as Da-Lite’s
No. 6, No. 11 or No.23
brackets must be used if
screen is to be wall 
mounted. Check with your
dealer to determine which
best fits your needs.

Brackets should be fastened
securely to a solid surface
such as a wooden 
reinforcement board and not
in the plaster only. Rarely
will wall studs be found to
support both ends of a
screen. Various types of 
fasteners are available from
local hardware stores.

FOR CEILING SUSPENSION

If the screen is to be ceiling
mounted, two screw hooks
placed in a beam or other
solid surface will do the job.
For dropped ceilings, Da-
Lite’s T-Bar Scissors Clip
may be purchased.

NOTE: Whichever method is used, the screen
should be free to swing forward and back and
not be anchored rigidly. Mount the screen so
that bottom of picture surface, when fully
extended, will be above heads of viewers.

YOU HAVE MADE A WISE
SELECTION…

Care in mounting and care in correct
operation will mean a long and satisfac-
tory life for your Da-Lite wall/ceiling
screen. Locate the screen where the
audience can best see it.

Summary of Contents for DELUXE MODEL B

Page 1: ...a Lite Project O Stands and Easels Da Lite Monitor Mounts POWER PRESENTATION PRODUCTS The In Operating Instructions for DELUXE MODEL B DA LITE SCREEN COMPANY INC 3100 North Detroit Street Post Office Box 137 Warsaw Indiana 46581 0137 Phone 574 267 8101 800 622 3737 Fax 574 267 7804 http www da lite com e mail info da lite com ...

Page 2: ...pport both ends of a screen Various types of fasteners are available from local hardware stores FOR CEILING SUSPENSION If the screen is to be ceiling mounted two screw hooks placed in a beam or other solid surface will do the job For dropped ceilings Da Lite s T Bar Scissors Clip may be purchased NOTE Whichever method is used the screen should be free to swing forward and back and not be anchored ...

Page 3: ...nsitive to temperature changes which may temporarily cause slight unevenness after a screen has been rolled up for a time If uneven when first opened for use put on normal tension with the ten sioning device and allow it to stand at room temperature of 70 to 75 degrees for five or ten minutes The surface will equalize itself and be normally flat for projection in a very short time SCREEN ACCESSORI...

Page 4: ...t the factory Should more tension be required the screw in the channel holding the upper tension arm assembly should be moved upward in holes allotted for this purpose For any adjustment it is recommended that the screen be removed placed on a flat surface and a pair of pliers and a Phillips screwdriver be used in removing the screw and nut PROTECT YOUR SCREEN Before re rolling surface into case e...

Reviews: