Da-Lite AdvantageManual With CSR, Instruction Book

Page: 2 / 8

2
Pre-Installation Operating Screen
Case Installation
Screen And Roller Assembly Installation
1. Carefully unpack case from shipping carton. DO NOT unpack
fabric and roller assembly yet.
2. Make sure to recheck measurement of case for proper
installation clearance.
3. Remove any protective foam or tape from case.
1. Pull down on pull bail until desired picture area is obtained.
Lock into position as on a window shade. Be sure surface is
locked before releasing.
NOTE:
this screen will not lock into position in the upper
portion of its travel.
2. To re-roll the screen, pull the picture surface down about 6 inches
and start the fabric up quickly and release.
Large picture surfaces are heavy and will start up too slowly to
prevent the locking pawl from catching unless help is provided.
If the locking pawl catches pull the picture surface down and
start the surface up rapidly.
The CSR feature of this screen will allow the fabric to retract
rapidly until about the last 6-12 inches of travel then it will slow
and retract gently into the case.
To view an online CSR retraction tutorial, please visit http://
www.da-lite.com/products/product_flash/modelc_csr/.
1. Hang case and attach to support structure with bolts.
See suggested methods of installation on page 3.
NOTE: Carriage bolts can be installed anywhere along the
length of the case. The head of the carriage bolt slides into
the variable-position mounting channel. It is recommended
that the center is supported on cases longer than 7 feet.
2. Tighten bolts until trim flange is flush with ceiling.
NOTE:
For proper operation, screen assembly must be
level after installation.
If your screen was shipped with the motor and roller already
installed, skip this section.
1. Remove access door. First remove the 2 screws from the
ends (Figure 1). Be sure to support the door during this step
to avoid injury. Lift the door slightly and pull away from the
edge of the case.
2. Carefully unpack screen and roller assembly. Leave packing
paper on roller.
3. Loosen (but do not remove) two 1/4-20 nuts securing the pin
end bracket (stage left) to the case housing. Slide the bracket
towards the end of the case.
4. Insert the spring end of the roller into the spring end bracket.
The mounting brackets have a formed tab that the slat bar
will rest against. Be sure to install the roller assembly so the
slat bar is positioned onto the tab. (Figure 2).
5. Slide the pin end bracket onto the CSR pin. Tighten the
1/4-20 nuts securely.
6. Re-install the access door. Procedure is reverse of removal.
Figure 1
Remove 2 Screws
To Remove
Access Door
Formed
Tab
Mounting
Bracket
Slat Bar
Figure 2