2
Pre-Installation
Case Installation
1. Carefully unpack case from shipping carton. DO NOT unpack
fabric and roller assembly yet.
2. Make sure to recheck measurement of case for proper
installation clearance.
3. Remove any protective foam or tape from case.
1. Hang case and attach to support structure with bolts.
See suggested methods of installation on page 3.
NOTE:
Carriage bolts can be installed anywhere along the
length of the case. The head of the carriage bolt slides into
the variable-position mounting channel. It is recommended
that the center is supported on cases longer than 7 feet.
2. Tighten bolts until trim flange is flush with ceiling.
NOTE:
For proper operation, screen assembly must be
level after installation.
Important Safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. Read and understand all instructions before using.
2. Failure to provide adequate structural strength for this
component can result in serious personal injury or damage to
equipment! It is the installer’s responsibility to make sure the
structure to which this component is attached can support the
weight of all equipment. Reinforce the structure as required
before installing the component.
3. Use this projection screen only for its intended use as described
in these instructions. Do not use attachments not
recommended by the manufacturer.
Save These Instructions
Disclaimer
Legrand AV Inc. and its affiliated companies and subsidiaries
(collectively, “Legrand AV”), intend to make this manual accurate
and complete. However, Legrand AV makes no claim that the
information contained herein covers all details, conditions or
variations, nor does it provide for every possible contingency in
connection with the installation or use of the products described
herein. The content herein is subject to change without notice or
obligation of any kind. To the maximum extent permitted by
applicable law, Legrand AV makes no representation or warranty,
expressed or implied, regarding the information contained
herein. Furthermore, Legrand AV assumes no responsibility for
accuracy, completeness or sufficiency of the information
contained in this document.
Da-Lite® is a registered trademark of Legrand AV.
All rights reserved.
