D-Teg TX4000B, User Manual

Page: 12 / 48

12
INSTALLATION
Park your vehicle on a flat level surface.
Turn off the engine before installing the TX4000.
1) Find installation location for TX4000 like Glove box, under dash, trunk.
2) Use provided Velcro adhesive to secure TX4000 recorder. Velcro can be
attached and detached freely.
NOTE: The adhesive will not stick well with dust or oil, etc.
Please make sure the surface is clean before applying.
3) Install the cameras(sold separately) with double side tape to the windshield
or other flat surfaces as been below. Adjust camera view. Make sure the lens
has an unobstructed view.
Interior Camera
Exterior Camera
4) Install the remote controller onto dash within reach of the driver using
provided double side tape.
5) Arrange the power cable neatly alongside of the windshield and door pillar
trim. The TX4000 requires a continuous 12/24volt power source from the
vehicle.
Connect the “Red cable ()” to a fuse (see
picture below). It should be connected to a fuse that has
power all the time from car battery. And the “White
cable(ACC+)” should be connected to a fuse that has
power when you start the engine. The ground cable
should be contacted at the car body or battery negative.
Start on the car after installation.