10
TESTING
1. Place the two red wires from the Test Light onto the
electrodes (as shown in the picture above).
2. Turn the unit ON using either magnet.
3. Slide the bottom of the test light (the serrated edge) across the top
of the sensor.
4. If the light comes on, the unit is functioning properly.
•
Higher intensity levels will cause the Tester to light up brighter.
•
If the tester doesn’t light, wait 3 seconds then repeat the process.
MAINTENANCE
•
It is very important to periodically clean your 1145DT No Bark
trainer for maximum performance. Regular cleaning will also
lengthen the life of your unit.
•
Clean the 1145DT collar box with lukewarm water and a mild
anti-bacterial soap.
•
Take care to thoroughly clean the space between the electrodes
and the belt.
•
The belt and buckle should be cleaned with water and a mild soap
then allowed to dry completely.
•
Always allow the entire unit to completely dry before
using. Never completely submerge the unit.
3
INTRODUCTION
Congratulations and Thank you for purchasing the
1145DT No Bark Training System. This collar is one
of the best and most advanced No Bark Trainers in
the World.
The 1145DT has been specially designed for training
your dog and for preventing excessive barking by
automatically sending out an electrical stimulation
whenever problem barking occurs. This training system
is ideal for all dog temperaments from the most stubborn
to the meekest.
IMPORTANT
It is recommended that you fully read and understand
this entire owner’s manual prior to operating your
1145DT No Bark Trainer. If you have any questions
or do not fully understand any part of this manual, or
the product’s features or operation please contact our
customer service department at the phone number or
address on the back of this manual.
The 1145DT is perfect for:
•
Preventing excessive barking at home, in a kennel or
while traveling.
•
Preventing your dog from howling at night.
•
Preventing your dog from barking in restricted areas.
