12
PARTS & FUNCTIONS CONT.
Collar Belt with Embedded Receiver Antenna
The embedded collar antenna ends at the displaced hole
midway along the belt.
CAUTION
Do not cut the collar belt. Doing so will damage the an-
tenna and may result in
severely decreased receiver range.
Collar Indicator Light
When the ON/OFF button on the Collar Receiver is
pushed, the RED light will flash steadily once every two
seconds to indicate that the unit is active.
The RED light changes to a rapid flash (twice per second)
when the battery is low and in need of charging.
Electrodes
Electrodes should fit snugly on the dog’s neck to ensure
good contact with the skin. For more information on the
proper fit of the collar see page (7).
Remote Training EZT 2000 Series
For the EZT 2000 Series, pressing the button located on
the West side of the Transmitter causes the Collar Re-
ceiver to Vibrate. Pressing the button located on the East
side of the Transmitter causes the Collar Receiver to Vi-
brate for .5 seconds. After .5 seconds, Continuous Stimu-
lation will be applied simultaneously with the Positive Vi-
bration.
9
TURNING ON AND OFF
Turning the Unit On:
Press and hold the On/Off button on the Collar Receiver.
The Red LED Indicator will light solidly for two seconds.
Continue holding the Button until the Red light goes off. The
unit is now On. The LED Indicator will now flash approxi-
mately every two seconds. (Note: The Transmitter is always
in a permanent sleep state. It is only On when a button is
being pressed, and does not need to be turned off by the
user).
Turning the Unit Off:
When you are ready to shut the unit off, simply press and
hold the On/Off button for three seconds. Again the Red
LED indicator will light solidly for two seconds. Hold the
Button until the light goes off. The Unit is now Off.
PARTS & FUNCTIONS CONT.
