DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
107
Priority-2 -> <Class-0>
Priority-3 -> <Class-1>
Priority-4 -> <Class-2>
Priority-5 -> <Class-2>
Priority-6 -> <Class-3>
Priority-7 -> <Class-3>
DES-3526:admin#
config 802.1p default_priority
Purpose
Used to configure the 802.1p default priority settings on the Switch. If
an untagged packet is received by the Switch, the priority configured
with this command will be written to the packet’s priority field.
Syntax
config 802.1p default_priority [<portlist> | all] <priority 0-7>
Description
This command allows specification of a default priority handling of
untagged packets received by the Switch. The priority value entered
with this command will be used to determine which of the seven
hardware priority queues the packet is forwarded to.
Parameters
<portlist>
−
Specifies a port or range of ports to be configured. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2, port 4
−
in numerical order. Non-contiguous portlist entries are separated by
a comma. (ex: 1:1-1:3,1:7-1:9)
all
−
Specifies that the command applies to all ports on the Switch.
<priority 0-7>
−
The priority value to assign to untagged packets
received by the Switch or a range of ports on the Switch.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To configure 802.1p default priority on the Switch:
DES-3526:admin#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DES-3526:admin#
show 802.1p default_priority
Purpose
Used to display the currently configured 802.1p priority value that
will be assigned to an incoming, untagged packet before being
forwarded to its destination.
Syntax
show 802.1p default_priority {<portlist>}
Description
The show 802.1p default_priority command displays the currently
configured 802.1p priority value that will be assigned to an
incoming, untagged packet before being forwarded to its
destination.
Parameters
<portlist>
−
Specifies a port or range of ports to be configured. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
