xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config ports
from the
master
. If one connection is set for
1000 master
, the
other side of the connection must be set for
1000 slave
. Any other
configuration will result in a link down status for both ports.
None
denotes the Switch will serve no role for stacking.
flow_control [enabled | disabled]
– Enable or disable flow control
for the specified ports.
learning [enabled| disabled]
−
Enables or disables the MAC
address learning on the specified range of ports.
state [enabled | disabled]
−
Enables or disables the specified
range of ports.
description <desc 32>
- Enter an alphanumeric string of no more
than 32 characters to describe a selected port interface.
clear
– Enter this command to clear the port description of the
selected port(s).
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure the speed of port 3 of unit 1 to be 10 Mbps, full duplex, learning and state enable:
DES-6500:4#config ports 1:1-1:3 speed 10_full learning enabled state enabled
Command: config ports 1:1-1:3 speed 10_full learning enable stated enabled
Success.
DES-6500:4#
show ports
Purpose
Used to display the current configuration of a range of ports.
Syntax
show ports {<portlist>} {description}
Description
This command is used to display the current configuration of a
range of ports.
Parameters
{<portlist>}
−
Specifies a range of ports to be displayed. The port
list is specified by listing the lowest slot number and the beginning
port number on that slot, separated by a colon. Then the highest
slot number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
specifies all of the ports between slot 1, port 3 and slot 2, port 4
−
in numerical order.
{description}
– Adding this parameter to the command will allow
the user to view previously configured descriptions set on various
ports on the Switch.
Restrictions None.
Example usage:
To display the configuration of all ports on a standalone switch:
26