D-Link DCS-910/90 Quick Install Guide
Hardware Installation
Hardware Installation
Note:
It is required that an Ethernet cable is used during initial
setup. Once your wireless configuration is set, you may disconnect
the Ethernet cable and begin communicating wirelessly with your
DCS-920.
Attach the Swivel Stand
Locate the stand mount on the back
panel of the DCS-910/920 and screw on
the swivel stand to the DCS-910/920.
Attach the Antenna
Locate the antenna included with your
DCS-920 and attach it to the antenna
connector located on the back of the
DCS-920.
Note:
Wireless Antenna is provided
with the DCS-920 only.
Connect the Ethernet Cable
Connect the included Ethernet cable to
the network cable connector located on
the bottom panel of the DCS-910/920
and attach it to the network. Network
Connectivity is confirmed when the
green LED Indicator on the camera is
illuminated.