-10-
CAT-5 UTP Fast Ethernet Cable
Panel Layout
Front Panel
M1&M2
System status indicators,
Orange
. M1 is flashed once per second to
indicate system is active. When system is busy, M2 is lighted.
Broadband &
LAN
Ethernet port indicators,
Green
. The LED flickers when the LAN or WAN
port is sending or receiving data.
Link/Act.
Link status indicators,
Green
. The LED flickers when the corresponding
port is sending or receiving data
10/100
10/100 status indicators,
Green
. The LED flickers when the
corresponding port is transmitting or receiving data in 10 or 100Mbps.
Side Panel
RESET
To reset system settings to factory defaults, please follow the steps:
1.
Power off the device
2.
Press the reset button and hold
3.
Power on the device
4.
Keep the button pressed about 5 seconds
5.
Release the button
6.
Watch the M1 and M2 LEDs, they will flash 8 times and then the
M1 will flash once per second
POWER
Power port. Connect one end of your included power adapter to the
power port and the other end into your power outlet
