To check for the proper installation of
your DFE-670TXD, please go to
START > SETTINGS > CONTROL
PANEL>
Double click on the SYSTEM icon.
At the SYSTEM PROPERTIES
window,click on the HARDWARE
tab, and then click on the DEVICE
MANAGER tab.
Your DFE-670TXD will appear under
NETWORK ADAPTERS, as shown.
Category 5 UTP cable can be used for both
Fast Ethernet cabling and for traditional
Ethernet cabling.
Cat5 cable is required for Fast Ethernet operation.
The maximum cable length between the DFE-
670TXD and the supporting hub is 300 ft. The
cable must be straight (not a crossover cable),
with an RJ-45 plug at each end.
Category 3, Category 4, and Category 5 UTP cable, as well as EIA/TIA-
568 100-ohm STP cable, all qualify under traditional Ethernet cabling rules. The
maximum cable run between the DFE-670TXD and the supporting hub is 300 ft.
The cable must be straight (not a crossover cable) with an RJ-45 plug at each end.
Connecting for Fast Ethernet cabling
Connecting for traditional (10Mbps) Ethernet cabling
Connecting Your Network Cable
A
A P P E N D I X
B
A P P E N D I X
M-DFE-670TXD-NEW.QXD 3/15/2001 11:01 AM Page 12
