D-Link EasySmart Switch User Manual
Figure 41 – L2 Feautres > IGMP Snooping setting
L2 Features > Port Mirroring
Port Mirroring is a method of monitoring network traffic that forwards a copy of each incoming and/or
outgoing packet from one port of the Switch to another port where the packet can be studied. This enables
network managers to better monitor network performances.
Figure 42 –L2 Features > Port Mirroring
Selection
Sniffer Mode
for the Source Ports are as follows:
TX (transmit) mode:
Duplicates the data transmitted from the source port and forwards it to the Target Port.
Click “all” to include all ports into port mirroring.
RX (receive) mode:
Duplicates the data that received from the source port and forwards it to the Target Port.
Click “all” to include all ports into port mirroring.
Both (transmit and receive) mode:
Duplicate both the data transmitted from and data sent to the source
port, and forwards all the data to the assigned Target Port. Click “all” to include all ports into port mirroring.
NOTE:
The target ports will stop mirroring packets
if there are unknown tags or destination packets
sent out by source ports.
L2 Features > Loopback Detection
The Loopback Detection function is used to detect the loop created by a specific port while Spanning Tree
Protocol (STP) is not enabled in the network, especially when the down links are hubs or unmanaged
switchs. The Switch will automatically shut down the port. The Loopback Detection port will be unlocked
when the Loopback Detection
Recover Time
times out. The Loopback Detection function can be
implemented on a range of ports at a time. You may enable or disable this function using the pull-down menu.
23
Summary of Contents for EasySmart DGS-1100-16
Page 1: ......
Page 36: ...D Link EasySmart Switch User Manual Figure 57 Security Dynamic Forwarding Table 33 ...
Page 41: ......
