DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide
9
MIB, OSPFv2 MIB, VRRP MIB, Private MIB,
Entity MIB.
Front Panel Components
The front panel of the switch consists of LED indicators, an SD card slot, an Out-Of-Band Management port (MGMT),
a Console port, SFP+ ports and an open module slot.
Figure 1-1 Front panel view of the DXS-3600-16S
Figure 1-2 Front panel view of the DXS-3600-32S
Ports that can be found on the front panel of this switch are listed in the table below.
Port
Description
SD Card Slot
This port can be used to insert an external SD memory card. The maximum
capacity SD card that can be inserted into this port is 32Gb.
Management port (MGMT)
This port is a 10/100/1000Mbps Ethernet port with an RJ-45 connection. This
Out-Of-Band management port that can be used to configure this switch without
being connected to the network.
Console port
This port is an RJ-45 connection port that can be used to connect to the
Command Line Interface (CLI) of this switch for configuration, management and
monitoring. This port uses a special console cable (included with the packing)
with a DB9 interface to connect the Switch to a PC’s COM port.
10 Gigabit ports
This switch is equipped with SFP/SFP+/WDM ports. These ports can operate at
10Gbps speeds and support a vast collection of SFP/SFP+/WDM transceivers.
Expansion Module Slot
This slot can be equipped with 4 kinds of additional modules. These modules are
not included and should be bought separately.
DXS-3600-EM-4XT
(Four 10GBASE-T Copper ports).
DXS-3600-EM-8T
(Eight 1000BASE-T Copper ports).
DXS-3600-EM-4QXS
(Four 40Gbps QSFP+ transceiver slots).
DXS-3600-EM-8XS
(Eight 10Gbps SFP+ transceiver slots).
DXS-3600-EM-Stack
(Two 120Gbps CXP Stacking ports). This module
can only be used with the
DXS-3600-32S
For a complete list of SFP/SFP+/WDM/QSFP+ transceivers, that are compatible with this switch, refer to the “
Product
Specifications
” section in
Figure 1-3 Front panel view of the DXS-3600-32S with EM-4XT module
