D-Link DWS-4000 Series, Cli Command Reference

Page: 444 / 566

D-Link Unified Switch CLI Command Reference
436
© 2009 D-Link Corporation. All Rights Reserved
SNTP
AND
C
LOCK
C
OMMANDS
This section describes the commands you use to automatically configure the Simple Network Time Protocol (SNTP)
commands, and the time zone and daylight savings time commands.
SNTP C
OMMANDS
sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power of two where
<poll-interval>
can be a value from 6 to 16.
no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and may set the mode to either broadcast or
unicast.
<url> nvram:sslpem-root
Downloads an HTTP secure-server certificate. For more
information, see
“Hypertext Transfer Protocol Commands” on
page 485 .
<url> nvram:sslpem-server
Downloads an HTTP secure-server certificate.
<url> nvram:startup-config
Downloads the startup configuration file to the system.
<url> nvram:system-image
Downloads a code image to the system.
<url> {image1 | image2}
Download an image from the remote server to either image.
{image1 | image2} <url>
Upload either image to the remote server.
image1 image2
Copy
image1
to
image2
.
image2 image1
Copy
image2
to
image1
.
Default 6
Format
sntp broadcast client poll-interval <poll-interval>
Mode Global Config
Format
no sntp broadcast client poll-interval
Mode Global Config
Default disabled
Format
sntp client mode [broadcast | unicast]
Mode Global Config
Table 11: Copy Parameters (Cont.)
Source Destination Description