D-Link DWS-4000 Series, Cli Command Reference

Page: 152 / 566

D-Link Unified Switch CLI Command Reference
144
© 2009 D-Link Corporation. All Rights Reserved
Extended POE PSE
Available: 0.3 Watts
Source: primary
Priority: critical
Extended POE PD
Required: 0.2 Watts
Source: local
Priority: low
show lldp med remote-device
Use this command to display the summary information about remote devices that transmit current LLDP MED data to the
system. You can show information about LLDP MED remote data received on all valid LLDP interfaces or on a specific
physical interface.
Example: The following shows example CLI display output for the command.
(DWS-4026) #show lldp med remote-device all
LLDP MED Remote Device Summary
Local
Interface Remote ID Device Class
--------- --------- ------------
0/8 1 Class I
0/9 2 Not Defined
0/10 3 Class II
0/11 4 Class III
0/12 5 Network Con
show lldp med remote-device detail
Use this command to display detailed information about remote devices that transmit current LLDP MED data to an interface
on the system.
Format
show lldp med remote-device {<slot/port> | all}
Mode Privileged EXEC
Term Definition
Local Interface The interface that received the LLDPDU from the remote device.
Remote ID An internal identifier to the switch to mark each remote device to the system.
Device Class Device classification of the remote device.
Format
show lldp med remote-device detail <slot/port>
Mode Privileged EXEC