D-Link DWS-4000 Series, Cli Command Reference

Page: 103 / 566

95
Static MAC Filtering
show monitor session
This command displays the Port monitoring information for a particular mirroring session.
S
TATIC
MAC F
ILTERING
The commands in this section describe how to configure static MAC filtering. Static MAC filtering allows you to configure
destination ports for a static multicast MAC filter irrespective of the platform.
macfilter
This command adds a static MAC filter entry for the MAC address
< macaddr >
on the VLAN
< vlanid >
. The value of the
< macaddr >
parameter is a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The restricted MAC Addresses
are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF. The
< vlanid >
parameter must identify a valid VLAN.
The number of static mac filters supported on the system is different for MAC filters where source ports are configured and
MAC filters where destination ports are configured.
• For unicast MAC address filters and multicast MAC address filters with source port lists, the maximum number of static
MAC filters supported is 20.
• For multicast MAC address filters with destination ports configured, the maximum number of static filters supported is
256.
Default enabled
Format
no monitor
Mode Global Config
Note: The
<session-id>
parameter is an integer value used to identify the session. In the current version of
the software, the
<session-id>
parameter is always one (1).
Format
show monitor session <session-id>
Mode Privileged EXEC
Term Definition
Session ID An integer value used to identify the session. Its value can be anything between 1 and the maximum
number of mirroring sessions allowed on the platform.
Monitor Session
Mode Indicates whether the Port Mirroring feature is enabled or disabled for the session identified with
<session-id>
. The possible values are Enabled and Disabled.
Probe Port Probe port (destination port) for the session identified with
<session-id>
. If probe port is not set then
this field is blank.
Source Port The port, which is configured as mirrored port (source port) for the session identified with
<session-
id>
.
If no source port is configured for the session then this field is blank.
Type Direction in which source port configured for port mirroring.Types are tx for transmitted packets and rx
for receiving packets.