D-Link DWS-1008 User Manual
8
Configuring an Ignore List
By default, when countermeasures are enabled, MSS considers any non-D-Link transmitter to be a
rogue device and can send countermeasures to prevent clients from using that device. To prevent MSS
from sending countermeasures against a friendly device, add the device to the known devices list:
If you add a device that MSS has classified as a rogue to the permitted vendor list or permitted SSID list,
but not to the ignore list, MSS can still classify the device as a rogue. Adding an entry to the permitted
vendor list or permitted SSID list merely indicates that the device is from an allowed manufacturer or is
using an allowed SSID. However, to cause MSS to stop classifying the device as a rogue, you must add
the device’s MAC address to the ignore list.
To add a device to the ignore list, use the following command:
set rfdetect ignore
mac-addr
The mac-addr is the BSSID of the device you want to ignore.
Note: If you try to initiate countermeasures against a device on the ignore list, the ignore list takes
precedence and MSS does not issue the countermeasures. Countermeasures apply only to rogue
devices.
To ignore BSSID aa:bb:cc:11:22:33 during all RF scans, type the following command:
DWS-1008#
set rfdetect ignore aa:bb:cc:11:22:33
success: MAC aa:bb:cc:11:22:33 is now ignored.
To remove a BSSID from the ignore list, use the following command:
clear rfdetect ignore
mac-addr
To display the ignore list, use the following command:
show rfdetect ignore
The following command displays an ignore list containing two BSSIDs:
DWS-1008#
show rfdetect ignore
Total number of entries: 2
Ignore MAC
-------------------------
aa:bb:cc:11:22:33
aa:bb:cc:44:55:66
Summary of Contents for DWS-1008
Page 1: ......
