D-Link DWS-1008, Product Manual

Page: 143 / 502

D-Link DWS-1008 User Manual 1
Parameter Default Value
bias high
blink (Not shown in show dap config output) disable
force-image-download disable (NO)
group (load balancing group) none
mode disabled
persistent none
upgrade-firmware (boot-download-enable) enable (YES)
radio num auto-tune max-power default
radio num mode enabled
radio num radio-profile default
radiotype 11g (or 11b for country codes where 802.11g is not allowed)
APs that receive their configurations from the Auto-AP profile also receive the radio settings from the
radio profile used by the Auto-AP profile. Likewise, the SSIDs and encryption settings come from the
service profiles mapped to the radio profile. To use a radio profile other than default, you must specify
the radio profile you want to use.
Changing AP Parameter Values
The commands for configuring AP and radio parameters for the Auto-AP profile are the same as the
commands for configuring an individual Distributed AP. Instead of specifying a Distributed AP number
with the command, specify auto.
AP Parameters:
set dap auto bias {high | low}
set dap auto blink {enable | disable}
set dap auto force-image-download {enable | disable}
set dap auto group
name
set dap auto mode {enable | disable} set dap auto persistent [ dap-num | all]
set dap auto upgrade-firmware {enable | disable}
Radio Parameters:
set dap auto radiotype {11a | 11b| 11g}
set dap auto radio {1 | 2} auto-tune max-power
power-level
set dap auto radio {1 | 2} mode {enable | disable}
set dap auto radio {1 | 2} radio-profile
name
mode {enable | disable}