D-Link DWR-112, User Manual, Page: 72 / 119

68 D-Link DWR-112 User Manual
Section 3 - Configuration
Set the transmit power of the antennas.
Beacons are packets sent by an Access Point to
synchronize a wireless network. Specify a value.
100 is the default setting and is recommended.
This value should remain at its default setting of
2432. If inconsistent data flow is a problem, only
a minor modification should be made.
The fragmentation threshold, which is specified
in bytes, determines whether packets will be
fragmented. Packets exceeding the 2346 byte
setting will be fragmented before transmission.
2346 is the default setting.
(Delivery Traffic Indication Message) 1 is the
default setting. A DTIM is a countdown informing
clients of the next window for listening to
broadcast and multicast messages.
Select Short or Long Preamble . The preamble defines the length of the CRC block (Cyclic Redundancy Check is a common
technique for detecting data transmission errors) for communication between the wireless router and the roaming wireless
network adapters. Note: High network traffic areas should use the
Short Preamble
type.
Use the drop-down menu to select the wireless modes you want to enable on the router. The available options are 802.11n
only , 802.11 Mixed(g/b) , and 802.11 Mixed(n/g/b) .
This setting can be used to adjust the bandwidth of the wireless signal. The default setting is
20/40 MHz (Auto)
.
Check this box to reduce the guard interval time therefore increasing the data capacity. However, it’s less reliable and may
create higher data loss.
Transmit
Power:
Beacon Period:
RTS Threshold:
Fragmentation:
DTIM Interval:
Preamble
Type:
Wireless Mode:
Band Width:
Short Guard
Interval:
Advanced Wireless Settings