28
DWL-8220AP User’s Manual
D-Link Systems, Inc.
Installation (continued)
Installation
2.
When the link is activated, observe the AP LED for the port on the DWS-1008 switch:
AP LED Appearance
Meaning
Solid green
For an access point’s active link, all the
followng are true:
• Access point has booted.
• Access point has received a valid configuration
from the switch.
• Management link with an access point is
operational.
• At least one radio is enabled or is in sentry mode.
For an access point’s secondary link, the link is
present.
Alternating green and amber
Access point is booting with an image received
from the switch. After the access point boots and
receives its configuration, this LED appearance
persists until a radio is enabled or is placed in
sentry mode.
Solid amber
PoE is on.
Blinking amber
AP is unresponsive or there is a PoE problem.
No Light
PoE is off.
Note:
A DWS-1008 switch’s 10/100 Ethernet ports are configured as wired network ports
by default. You or the system administrator must change the port type for a DWS-1008 port
directly connected to an AP to activate the link.
Verifying AP Health
After you install the access point and enable PoE on the Ethernet cable connected to the AP,
you can easily verify the AP’s status by observing the LEDs, particularly the health LED.
The health or LINK LED indicates whether the access point is ready for operation.
• If the LED is green and glowing steadily, the AP has been booted successfully by the
switch and is ready for operation.
• If the LED is not steadily glowing green, contact the system administrator for the
switch or, if you are the system administrator, refer to the Troubleshooting section.
Summary of Contents for DWL-8220AP - AirPremier Wireless Switch Dualband Access Point
Page 1: ......
