4
D-Link Unified Services Router
E
N
G
LI
S
H
To access the device with the WebUI:
1. Connect your workstation on the port labeled
LAN (1-8), which is pre-allocated to the LAN.
2. Ensure your workstation is DHCP Client
enabled or configured with a static IP address
in the 192.168.10.0/24 subnet.
Note:
Disable pop-up blocking software
or add the management IP address
http://192.168.10.1 to your pop-up blocker’s
allow list.
3.
Launch your browser; enter the IP address
for the LAN interface. (The factory default IP
address is
http://192.168.10.1)
, then press
Enter
.
4.
Log on the
Services Router Web Interface The
default log on information is:
Username:
admin
Password:
admin
Connecting the Device to a Network
Initially Configure the Device
The services router software is preinstalled on the
DSR-250 device. When the device is powered on,
it is ready to be configured. While the device has
a default factory configuration that allow you to
initially connect to the device, you must perform
further configuration for your specific network
requirements.
Using the WebUI
To use the WebUI, the workstation from which you
are managing the device must initially be on the
same subnetwork as the device.
Figure 6. Authentication Message
Figure 5. Browser Address
Table 4. Browser Compatibility
Browser
Version
Microsoft Internet
Explorer
6.0 and Later
Mozilla Firefox
3.5 and Later
Netscape Navigator
9.0 and Later
Apple Safari
4.0 and Later
Google Chrome
3.0 and Later
This section provides basic information about
physically connecting the DSR-250 to a network.
To connect the necessary cables as shown in
Figure 3.
1. Connect an RJ-45 cable from the port labeled
WAN to the external router. The port WAN is
pre-allocated to the WAN network segment.
2. Connect an RJ-45 cable from the port labeled
LAN (1-8) to a switch in the LAN network
segment.
3. Connect an RJ45-to-DB9 cable from the
console port for CLI (Command Line Interface)
management access.
Figure 3. Basic Cabling Example
WAN1
LAN
Console
Internet
Switch
User