D-Link DSN-3200-20 - Xstack 8X1GBE Iscsi San Array 15 Bays..., Quick Installation Manual

Page: 12 / 20

D-Link DSN-3200/3400 Installation Guide
12
Installing the DSN-3400
Insert an Ethernet crossover cable
into the management port of the
DSN-3000 series and connect the
other end to your management
system’s open Ethernet port (the one
set to IP address 192.168.1.2).
Note:
The management port of the
DSN-3000 series does not support
MDI and will require a crossover
cable. Or if you wish, two standard
straight-through cables may be used
with an intermediate switch or hub.
The management port is 100MbE.
Insert an Ethernet cable into the
10GbE Host Network Connection of
the DSN-3000 series as identified
on page 7 and the other end to the
10GbE port of your SAN network.
Insert each of the three power cables
into the power supply as shown
below. And then plug the other end
of these power cables into a reliable
filtered power source such as a UPS
(Uninterruptible Power Supply).
1
2
3
Proceed to Software Installation Overview for the
DSN-3000 series.