D-Link DSM-G600 - MediaLounge Wireless G Network Storage Enclosure NAS Server, Install Manual

Page: 7 / 312

7
Installing the Hard- Installing the Hardware
Installing the Hardware (continued)
E. Use the mounting screw to
secure the hard drive to the
DSM-G600. Replace the
cover and screw the two
screws on the back panel
of the DSM-G600.
D. While facing the back of
the DSM-G600, insert the
right side of the hard drive
into the case. Once in
place, snap down the left
side.
F. Connect an Ethernet
cable to the Ethernet port
located on the back of the
DSM-G600.
Note: It is required that an Ethernet cable is used during initial setup. Once
your wireless configuration is set, you may disconnect the Ethernet cable and
begin communicating wirelessly with your DSM-G600.