DSL-502T ADSL Router User’s Guide
1. Click
the
Connection 1
button under
WAN Setup
to view the default
PPPoA Connection Setup
configuration menu.
2. Select
PPPoE
from the
Type:
pull-down menu. The menu will blink momentarily
3. Type in a
Name:
for the connection or use the default name in the space provided
(
conn_1_PPPoE_8_35
used in the above example).
4. Under
Options
, enable
NAT
and/or
Firewall
by selecting the corresponding selection box.
5. If you are told to change the
VPI
or
VCI
values, type in the values given to you by your service
provider. Many users will be able to use the default settings.
6. Leave
the
default
QoS
values if you are unsure or the ISP did not provide this information.
7. Do not change the
PCR
or
SCR
values unless you are required to do so. If you are told to change these,
type in the values given to you by your service provider.
8. Type
the
Username
and
Password
used to verify the identity of your account. Typically, the Username
is an account number assigned by your ISP and appears in the form
account#@serviceprovider.com
,
while the Password may have been chosen by the account holder. For most users, the remaining settings
will not need to be changed. See your ISP for further information.
9. Click
the
Apply
button when you have entered all the information. The web browser will briefly go
blank. You are now finished changing setting for the primary WAN connection known as Connection 1.
It is now necessary to save the changes you just made and restart the Router.
10. To save the changes made to Connection 1, click the
Tools
tab and then click on the
System
Commands
button. Click on the
Save All
button to store the configuration settings. Click on
Back
button to return to the System Commands menu.
11. Check the WAN connection status. Click the
Status
tab and then the
Connection Status
button. Look
under
WAN
to view the
State
of Connection 1, it should read
Connected
. If the WAN connection state
does not appear to
Connected
after a few minutes, go back to the Connection 1 Setup menu, check the
settings and make sure they are correct.
Configure Connection 1 for Bridge
“Bridge” means a pure bridged connection with no IP address assigned to the Router. This connection method
makes the Router act as a bridge, and just passes packets across the DSL port. When the device is used in this
manner, it is necessary to install additional connection software on any computer or server used to access the
Internet.
21
Summary of Contents for DSL-502T
Page 1: ...DSL 502T ADSLRouter User sGuide First Edition February 2004 651DSL502T01 ...
Page 16: ......
Page 86: ......
Page 91: ......
