DSL-322T ADSL Modem User Guide
25
1.
Click the
Bridge Mode
radio button
in the WAN Settings section in the middle of the window.
2.
The settings under ATM VC Setting at the top of the window should not be changed unless you have been
instructed to change them. However, if you are instructed to change the
VPI
or
VCI
values, type in the values
assigned for your account. Leave the
Virtual Circuit
setting at the default (
Enabled
) value for now.
3.
Under the Bridge Mode heading, choose the
Connection Type
from the pull-down menu. This defines both
the connection type and encapsulation method used for your ADSL service. The available options are
1483
Bridged IP LLC
and
1483 Bridged IP VC-Mux.
If you have not been provided specific information for the
Connection Type
, leave the default setting.
4.
Most users will not need to change ATM settings. If this is the first time you are setting up the ADSL
connection it is recommended that you leave the
Service Category
settings at the default values until you have
established the connection. See the table on page 26 for a description of the parameters available for ATM
traffic shaping.
5.
When you are satisfied that all the WAN settings are configured correctly, click the
Apply
button.
6.
The new settings must be saved and the Modem must be restarted for the settings to go into effect. To save and
reboot the Modem, click on the
Tools
directory tab and then click
System
. Next click the
Save and Reboot
button in the lower half of the
System Settings
window.
7.
Click
OK
when the following “Save and restart?” dialog box opens.
8.
The Modem will save the new settings and restart. Upon restarting the Modem will automatically establish the
WAN connection.
