DSL-2750U
Quick Installation Guide
CONNECTING TO PC
PC with Ethernet Adapter
1. Make sure that your PC is powered off.
2. Connect an Ethernet cable between any of four Ethernet ports located on
the back panel of the router and the Ethernet port of your PC.
3.
To connect via 3G network:
connect your USB modem to the USB port
located on the left side panel of the router.
!
If you need to connect or change a USB modem to another one when
the router is powered on, power off the router, connect the modem to
the USB port, and power on the router.
4.
To connect the router to a DSL line:
connect a phone cable between the
DSL port of the router and the
ADSL OUT
port of the splitter. Connect
your phone to the
PHONE
port of the splitter. Then connect another
phone cable between a phone jack and the
ADSL IN
port of the splitter.
5.
To connect the router to an Ethernet line:
connect the Ethernet cable
between any of four Ethernet ports located on the back panel of the router
and the Ethernet line.
6. Connect the power cord to the power connector port on the back panel of
the router, then plug the power adapter into an electrical outlet or power
strip.
7. Turn on the router by pressing the
ON/OFF
button on its back panel.
8. Turn on your PC and wait until your operating system is completely
loaded.
Now you should configure your PC to obtain an IP address automatically (as
DHCP client).
3 It is recommended to use a USB extension cable to connect a USB modem to the
router.
5
