DMS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
36
•
Select the appropriate serial port (COM1 or COM2).
•
Set the data rate to 115200 baud.
•
Set the data format to 8 data bits, 1 stop bit, and no parity.
•
Set flow control to none.
To be able to view the boot procedure, the Switch needs to be rebooted. The simplest way, at this stage, to reboot the
Switch is to unplug and re-insert the power cable from and into the power receptacle on the back of the Switch.
After correctly configuring the terminal settings and re-inserting the power cable, the boot procedure will appear in the
terminal.
Boot Procedure V5.00.001
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100 %
MAC Address : F0-7D-68-36-30-00
H/W Version : A1
Please Wait, Loading 1.00.B009 Runtime Image ............... 100 %
UART init ................................................. 100 %
Starting runtime image
Device Discovery .......................................... 100 %
Configuration init ........................................ 100 %
After the boot sequence has been completed, the console login screen will be displayed.
Connecting to the Switch for the First Time
The Switch supports user-based security that can prevent unauthorized users from accessing the Switch or changing
its configuration. This section will explain how to log into the Switch’s Command Line Interface via the out-of-band
console connection.
Upon initial connection to the Switch, the login screen appears (see example below).
DMS-3130-30TS Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.B009
Copyright(C) 2018 D-Link Corporation. All rights reserved.
Switch>
By default, there is no
Username
and
Password
configured in the account settings of this switch for console
connection. This will allow the user to simply connect to this Switch for the first time by pressing the ‘
Enter
’ key.
After
pressing
Enter
, access will be given to enter commands after the command prompt (
Switch>
) appears.
NOTE:
The first user automatically gets Administrator level privileges. At least one
Administrator-level user account must be created for the Switch.
NOTE:
It is highly recommended to create a user account containing a username and a
password on the Switch to prevent unauthorized access to the management interface.
