DG-104SH VoIP Station Gateway
7
Command Line Interface
The DG-104SH VoIP gateway offers a line-at-a-time prompt and response scheme to execute various configuration
instructions. The interface displays a single prompt character
ggdbg>
when it is ready to accept a command (ex.
ggdbg>set
or
ggdbg>show
).
Typing a question mark after the
ggdbg>
prompt will display a list of helpful user commands. Please note that all
characters must be entered in lower case. For the sake of explanation, all command line examples in this chapter
are in
bold
type.
See below for a list of some of the most commonly used commands, parameter(s), and examples of their usage.
General Setup Commands
nwdbg system reboot
Definition:
This command is used to restart the device.
Parameter(s):
None.
Example:
nwdbg system reboot
nwdbg save changes
Definition:
This command is used to save configuration changes into flash and then restart the device.
Parameter(s):
None.
Example:
nwdbg save changes
nwdbg factory reset
Definition:
This command is used to change all of the configuration data to the default values, save the
new configuration data into flash, and then restart the device.
Parameter(s):
None.
Example:
nwdbg factory reset
nwdbg un
<USERNAME>
Definition:
This command sets the username if there is a username string, or shows the
username/password if only
nwdbg un
is typed.
Parameter(s):
<USERNAME, maximum string length is 12 characters>
Example:
nwdbg un 123456789012
nwdbg pw
<PASSWORD>
Definition:
This command sets the password if there is a password string, or shows the
username/password if only
nwdbg pw
is typed.
Parameter(s):
<PASSWORD, maximum string length is 12 characters>
Example:
nwdbg pw
nwdbg slic
<0|1>
Definition:
This command changes the Subscriber Line Interface Circuit (SLIC) state to standby or
active, or shows the SLIC state if only
nwdbg slic
is typed.
Parameter(s):
<slic state, 0 : standby, 1 : active >
Example:
nwdbg slic 0
Summary of Contents for DG-104SH
Page 75: ......
