For instructions on configuration, please see your User's Manual.
B
APPENDIX
To check for the proper installation
of your DFE-680TX/TXD, please
click on
START > SETTINGS >
CONTROL PANEL>
, double click
on the
SYSTEM
icon. At the
SYSTEM PROPERTIES
window,
click on the
DEVICE MANAGER
tab. Your
DFE-680TX/TXD
will
appear under
NETWORK
ADAPTERS
, as shown.
Category 5 UTP cable can be used for both
Fast Ethernet
cabling and for
traditional
Ethernet cabling.
Cat5 cable is required for Fast Ethernet
operation. The maximum cable length between
the DFE-680TX/TXD and the supporting hub is
300 ft. The cable must be straight (not a
crossover cable), with an RJ-45 plug at each end.
Category 3, Category 4, and Category 5 UTP cable, as well as EIA/TIA-568 100-ohm STP
cable, all qualify under traditional Ethernet cabling rules. The maximum cable run
between the DFE-680TX/TXD and the supporting hub is 300 ft.
The cable must be straight (not a crossover cable) with an RJ-45 plug at each end.
Connecting for Fast Ethernet cabling
Connecting for traditional (10Mbps) Ethernet cabling
Connecting Your Network Cable
A
APPENDIX
12
