13
D-Link DFE-530TX+ User Manual
Section - Installation
NOTE: If your system’s motherboard WOL Connector does not fit the WOL Cable or does not have 3 pins, do not attempt
to force a connection or alter the components to fit. Doing so could permanently damage your computer.
The WOL function is system dependent, in addition to the following instructions, you may need to download WOL
software from INTEL or another manufacturer’s website.
Please consult your computer’s manual for specific BIOS settings.
The WOL Cable is an interconnect cable with standard 3-pin connectors on each end. Please follow the procedures
listed below to ensure proper installation of the WOL cable.
1. Connect either end connector of the WOL Cable to the NIC WOL Connector. Both ends of the WOL Cable are
identical, so either end may be used.
2. Examine the PC motherboard and/or refer to the manual for the motherboard to locate the corresponding WOL
Connector on the motherboard. The actual location is system dependent, but the motherboard may have a label
beside the WOL Connector. After you have located the WOL connector on the motherboard, connect the cable.
3. Power-ON the PC and press “Delete” or “F1” when prompted to enter the PCI/ISA BIOS CMOS Setup. Enable the
WOL function or the power-ON function of the PC. The name of this function is system dependent, but may be
located in a category heading titled something like Power Management. Refer to your computer’s manual for more
information regarding the CMOS Setup Utility and BIOS settings.
Connecting the WOL Cable
Summary of Contents for DFE-530TX+
Page 1: ......
