D-Link DES-3250TG Standalone Layer 2 Switch
Destination
, or
Mac Source
.
RMON Status
<
Disabled
>
To enable RMON capability, toggle
Disabled
to
Enabled
.
802.1x Status
To enable 802.1x port control access on a
global basis, toggle
Disabled
to
Enabled
.
Asymetric VLAN
<
Disabled
>
To enable Asymetric VLANs, toggle to
Enabled
. Please note that when the user sets
Asymetric VLANs to
Disabled
, then the
factory default VLAN setting is restored.
Syslog Global State
<
Disabled
>
To enable Syslog Global State, toggle to
Enabled
.
Serial Port Settings
The configure the serial port settings, open the
configuration
menu and click on the
Serial Port Settings
link. This window is
used to configure the console settings for the Command Line Interface or for a Telnet session.
Figure 7- 4. Serial Port Settings window
The
Serial Port Settings
window is used to change and view the Console settings for your switch. The default
Baud Rate
for
this switch is set at
9600
and may be altered from
119200
,
38400
, to
115200
to perform different functions. The
Data Bits (8),
Parity Bits (none)
and
Stop Bits (1)
are read only fields and cannot be changed using the web-based manager. The
Auto
Logout
field may be set to
Never, 2 minutes, 5 minutes, 10 minutes
, and
15 minutes,
depending on the time the user wishes
the Switch to be idle before automatically logging out. The default for this setting is 10 minutes.
MAC Notification
MAC Notification
is used to monitor MAC addresses learned and entered into the forwarding database. To globally set MAC
addresses on the Switch, 0pen the following screen by clicking
MAC Notification
on the
Configuration
menu.
35
