D-Link™ Hardware Installation Guide – DES-3200 Series Switch
Introduction - Ports
Page | 10
The following table lists the features and compatibility for each type of port present in the DES-3200-
10/18/26/28/28F.
10/100/1000BASE-T:
IEEE 802.3 compliant
IEEE 802.3u compliant
IEEE 802.3x flow control support in full-duplex
Auto MDI-X/MDI-II cross over supported except for speed 1000M
force mode
SFP Combo:
SFP Transceivers Supported:
DEM-310GT (1000BASE-LX)
DEM-311GT (1000BASE-SX)
DEM-312GT2 (1000BASE-SX)
DEM-314GT (1000BASE-LH)
DEM-315GT (1000BASE-ZX)
DEM-210 (Single Mode 100BASE-FX)
DEM-211 (Multi Mode 100BASE-FX)
WDM Transceiver Supported:
DEM-330T (TX-1550/RX-1310nm), up to 10km,Single-Mode
DEM-330R (TX-1310/RX-1550nm), up to 10km,Single-Mode
DEM-331T (TX-1550/RX-1310nm), up to 40km, Single-Mode
DEM-331R (TX-1310/RX-1550nm), up to 40km, Single-Mode
DEM-220T/R (BiDi 100BASE-BX)
Compliant to the following standards:
IEEE 802.3z compliance
2.IEEE 802.3u compliance
1000BASE-T Combo:
IEEE 802.3 compliant
IEEE 802.3u compliant
IEEE 802.3ab compliant
IEEE 802.3x flow control support in full-duplex
100BASE-FX:
IEEE 802.3 compliant
IEEE 802.3u compliant
IEEE 802.3x flow control support in full-duplex
SFP Transceivers Supported:
DEM-210 (Single Mode 100BASE-FX)
DEM-211 (Multi Mode 100BASE-FX)
DEM-220T/R (BiDi 100BASE-BX)
NOTE:
The SFP combo ports on the Switch cannot be used simultaneously with the corresponding
1000BASE-T ports. If both ports are in use at the same time (ex. port 25 of the SFP and port 25 of
the 1000BASE-T), the SFP ports will take priority over the combo ports and render the
1000BASE-T ports inoperable.
