D-Link DES-2110, User Manual

Page: 110 / 126

102
IGMP Snooping Commands
The IGMP Snooping commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following
table.
Command Parameters
config router_ports [add | delete] <portlist>
enable igmp snooping
disable igmp snooping
show router ports
show igmp_snooping
group
config igmp_snooping
[host_timeout <sec 1-16711450> |
router_timeout <sec 1-16711450>]
Each command is listed, in detail, in the following sections.
config router_ports
Purpose
Used to configure ports as router ports.
Syntax config router_ports [add | delete] <portlist>
Description This command allows you to designate a range
of ports as being connected to multicast-enabled
routers. This will ensure that all packets with
such a router as its destination will reach the
multicast-enabled router
− regardless of protocol,
etc.
Parameters add / delete - Add or delete the specifies a port
or range of ports that will be configure as router
ports.
<portlist> - Specifies a port or range of ports that
will be configured as router ports.