DE-220P Series Ethernet Adapter / User’s Guide
10
Installation
Multiple Cards in a Non-PnP
System
In non-PnP systems, the procedure for configuring
multiple DE-220P Series cards is basically a se-
quence of separate single-adapter procedures:
make a preliminary installation of each card alone
in turn, make a
setup.exe
run to configure that
card, then remove that card and go on to the next.
CAUTION:
The following procedure involves operation of the
computer without its chassis housing in place. Caution
is necessary in order to avoid contact with exposed
high-voltage parts. Accidental contact with exposed
internal parts can cause personal injury, and can cause
damage to the computer equipment.
1.
Make a preliminary installation of the first DE-
220P Series card by completing Steps 1 through 3
as set out in the “Single-Adapter Installation” sec- tion
above.
2.
Restore power to the computer, and configure the
card by running the supplied setup program,
setup.exe
. Make a note of the configuration
settings that you select, to help you select different
settings in configuring the remaining cards.
3.
Shut down the computer and unplug its power
cord. Remove the (configured) card, and install
the next DE-220P Series card into any open
expansion slot.
4.
Restore power to the computer, and configure the
card by running the supplied setup program,
