![background image](http://html.mh-extra.com/html/d-link/dcs-4633ev/dcs-4633ev_user-manual_77627016.webp)
16
D-Link DCS-4633EV User Manual
Section 2: Installation
Using the DCS-37-3 Mount (optional)
To mount the camera with the DCS-37-3 mount, follow the instructions below.
Step 2
Use the provided screws to mount the DCS-37-3 to the ceiling using the inner
mounting holes.
Step 1
Place the DCS-37-3 mounting sticker in the desired location, then use a 6 mm
drill bit to drill the required holes 25 mm deep and insert the wall anchors into
the holes. If you plan to pass cables through the ceiling, you will also need to drill
a hole for the cable channel.
Note:
The camera in the corresponding graphics may be different from your
product, but the procedure is the same.
Step 3
Remove the cover from the camera.
Guide the camera connectors through the bottom cable channel on the DCS-37-
3. Use the provided screws to mount the camera to the DCS-37-3 using the set
of mounting holes marked
D
.
Step 4
Remove the cover and adjust the angle and rotation of the camera as desired,
then put the cover back in place. Screw the camera cover back in place.
Make sure the rubber stopper is in the side cable channel to seal it.