D-Link DCS-2670L, Quick Install Manual

Page: 6 / 24

Mount the Camera
Please refer to the steps below to assist you with mounting the camera.
We suggest that you configure the camera before mounting.
2. Depending on the material of the wall or ceiling,
use proper tools to drill holes 25 mm deep with a 6
mm drill bit where you marked. If the wall is made
out of concrete, drill the holes first, then insert the
plastic anchors to support the screws.
3. Place the baseplate over the holes that are in the
wall. Make sure to align the baseplate holes with the
holes in the wall. Use the supplied screws to attach
the baseplate to the surface of the wall.
4. Place the camera over the baseplate and align the
nub with the hole on the camera. Attach the camera
by sliding it in the direction of the arrow.
1. Place the baseplate where you want to position the
camera and use a pencil to mark the holes. You can
use the large holes for a removable installation, or
the small holes for a fixed one. Make sure the lock
arrow on the plate is pointing down.
5. Once the camera is secured to the baseplate, use a
screwdriver to fasten the screw next to the hole at
the back of the camera body.
6. Adjust the angles via the camera body and rotate
the silver base until you achieve your desired
viewing angle.
1
2
3
4
5
6
6
EN
G
LI
S
H