DAP-300P
Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
WAN
This page is available if the
Router
or
WISP Repeater
mode was selected in the Initial
Configuration Wizard.
On the
Connections Setup
/ WAN
page, you can create and edit connections used by the access
point.
Figure 71. The
Connections Setup / WAN
page.
To create a new connection, click the
ADD
button (
) in the
Connections List
section. Upon
that the connection creation page opens
To edit an existing connection, in the
Connections List
section, left-click the relevant line in the
table. On the opened page, on the
Basic
tab, the mandatory settings of this WAN connection will
be displayed. To view all available settings of the WAN connection, go to the
All Settings
tab.
Change the needed parameters and click the
APPLY
button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the
RECONNECT
button.
To remove a connection, in the
Connections List
section, select the checkbox located to the left
of the relevant line in the table and click the
DELETE
button (
). Also you can remove a
connection on the editing page.
To allow multicast traffic (e.g. streaming video) for a connection, click the
IGMP
link (for the
description of the page, see the
To use one of existing WAN connections as the default IPv4 or IPv6 connection, in the
Default
Gateway
section, select the choice of the radio button which corresponds to this connection.
3 Setting up PPPoE, PPTP, L2TP, PPoE IPv6, and PPPoE Dual Stack WAN connections on the
Connections
Setup / WAN
page will become available in future software versions.
Page
80
of 175
