67
DWL-8200AP User’s Manual
D-Link Systems, Inc.
Using the AP Manager
Check to enable wireless mode.
The Service Set (network) Identifier of your wireless network.
Allows you to select a channel.
6
is the default setting.
Allows you to enable or disable the broadcasting of the SSID to
network clients.
Select this option to enable a wireless signal rate of up to
108Mbps.
Select
Enable
or
Disable
.
A pull-down menu to select the maximum wireless signal rate for
the selected device(s).
Beacons are packets sent by an access point to synchronize a
network. Specify the beacon value for the selected device(s) here.
The default value of
100
is recommended.
DTIM (Delivery Traffic Indication Message) is a countdown informing
clients of the next listening window for broadcast and multicast
messages.
This sets the fragmentation threshold (specified in bytes). Packets
exceeding the value set here will be fragmented. The default is
2346
.
The RTS value should not be changed unless you encounter
inconsistent data flow. The default value is
2346
.
Choose
full
,
half (-3dB)
,
quarter (-6dB)
,
eighth (-9dB)
,
minimum
power
. This tool can be helpful for security purposes if you wish to
limit the transmission range.
Select this option to automatically select the most optimal channel
available for wireless networking.
Wireless
:
SSID
:
Channel
:
SSID Broadcast
:
Super G
:
Radio Wave
:
Data Rate*
:
Beacon Interval
(20~1000)
:
DTIM (1~255)
:
Fragment Length
(256~2346)
:
RTS Length
(256~2346)
:
Tx Power
:
Auto Channel
:
IEEE 802.11g:
Device Configuration > Wireless
(continued)
*Maximum wireless signal rate derived from IEEE Standard 802.11a and 802.11g specifications. Actual
data throughput will vary. Network conditions and environmental factors, including volume of network
traffic, building materials and construction, and network overhead lower actual data throughput rate.
