Switch off the amplifier before making any
connections.
Connect an amplifier output channel terminal to
the enclosure’s input terminals using speaker
cable.
Peel off approximately 1cm of the cable’s
plastic jacket and insert the cable in the amplifier
outputs so that the bare wire cannot be touched.
Make sure you connect the enclosures with the
correct polarity.
The
VA series
provides connection area with
maximum protection against water and dust,
achieving an IP rating of IP-54.
Don’t remove this cover once assembled
The
VA-4T
and
VA-24T
include a transformer for
use on 70V/100V distribution lines.
They can be also used as low impedance
cabinets.
Use the switch to select the position that
corresponds to the required power, voltage line
and impedance.
AMPLIFIER
+
-
Remember to choose among the different
power positions of the multi-tap transformer:
For the
VA-4T
:
.- 8 ohms (low impedance position).
.- 5W/100V line.
.- 10W/100V line.
.- 15W/100V line.
.- 2.5W/70V line.
.- 5W/70V line.
.- 7.5W/70V line.
For the
VA-24T
:
.- 8 ohms (low impedance position).
.- 10W/100V line.
.- 20W/100V line.
.- 30W/100V line.
.- 5W/70V line.
.- 10W/70V line.
.- 15W/70V line.
Important, a line distributor amplifier should be
used if the line position is chosen.
Manual del Usuario
/ VA series /
User’s Manual
8
CONNECTION
VA-4T
VA-24T
