19
Manual del Usuario
/ SF series /
User’s Manual
To hang the units, the Allen-head screws must be removed and replaced by M10 eyebolts on one side of
the enclosure. Each rigging point has 200 kg (440 lb) working load limit.
Then choose the slings or chains of required load resistance and length, bearing in mind that the length
difference between the front and back slings or chains will determine the vertical orientation. Alternatively, the
back bottom eyebolt points can be used to provide vertical orientation.
The
ANL-2
set is an optional set of four eyebolts and four carabiners. (Dimensions are in milimetres).
Each
ANL-2
eyebolt has a rated working load of 200 kg. (440 lb). Each
ANL-2
carabiner has a working
load of 330 kg (726 lb). If using other hardware, make sure it is rated to handle the required load.
When using eyebolts it is important to bear in mind that the rated working load is only true for a load
applied in the plane of the eye, and is significantly reduced for other angles. The drawing illustrates the
concept.
The table shows the variation of the working load as a function of the load angle. In the case of the
ANL-2
eyebolt, this means that the 200 kg working load becomes 60 kg at 45 degrees. Do not use eyebolt flying if
the load angle is higher than 45 degrees.
Note: As always, when we handle heavy loads, we should wear appropriate clothing and
protective elements such as gloves, safety shoes, etc.
Next, you will see some examples, both horizontal and vertical array.
Frontal view
Side view
Horizontal Array
Rear view
Summary of Contents for Sound Froce SF-10
Page 13: ......
