17
Manual del Usuario
/ SF series /
User’s Manual
Now, we will screw each
JP-20
on the corresponding side, considering the angle assigned to the box, but
do not tighten completely. Allowing you to place easily the
SF-20A (L/R)
on
SF-1521A
.
Once the
SF-20A (L/R)
is located above of
SF-1521A
, you should tighten the screws into the appropriate
holes at the desired angle.
If the system has only a
SF-20A (L/R)
, then the system is already mounted.
But, to stack a second
SF-20A (L/R)
on top, first you proceed to remove the screws from the
SF-20A (L/R)
to mount another
JP-20
.
As in the previous case, each
JP-20
piece should be screwed in its corresponding side considering the
angle assigned to the box without fully tightening, to place easily the upper
SF-20A (L/R)
.
Once the
SF-20A (L/R)
is located above, tighten the screws into the appropriate holes at the desired
angle.
So, the
SF-Monitor
system (left or right) is mounted, according the angles to the desired coverage.
