D.A.S. RF-12.85, User Manual

Page: 19 / 28

13
Rigging with
AXA
AX-2RF12 / AX-2RF15
Array Frame.
Mounting instructions.
1.- Flip the speakers upside down. Remove the
existing speaker screws and rubber feet. Replace
the screws used to attach the rubber feet to keep
air from escaping.
2.- Position the speakers in the desired splay
angle.
3.- Attach the joining plates to the enclosure using
the holes on the concave side for the rear and the
holes on the convex side to determine the angle.
The holes closest to each other position the
enclosures side to side, forming a 20º angle
between them. Advancing toward the exterior
alternate holes on each side increment the angles
in 5º steps. It is recommended that the joining
plate be placed
as symetrically as pos-sible. Flat
washers should be placed adjacent to the joining
plates, followed by the lock washer and finally the
bolt.
4.- Slowly flip the speaker assembly so that the
tops of the speakers are facing up.
5.- Screw the joining plates to the enclosures
positioning the one with rigging points in the rear
so a pull point is available should we need steep
vertical angling.
6.- Screw the eyebolts into the two remaining
holes.
7.- Suspend the enclosures using the eyebolts and
the joining plate with rigging points.
Package contents
4 joining plates (1 with rigging points) 8
M10x30 screws, 8
Grower (split) M10 lock
washers, 8 M10 flat washers, 2 M10 eyebolts,
1 number 8 Allen (hex) wrench, 1 number 6
Allen wrench.
EN
Manual del Usuario
/ r / User’s Manual eference