CEILING SERIES
Manual del usuario /
User's manual
8
2.2 Installation
The different installation steps are described. Before this can
take place, the installation should be wired, leaving all of the
ceiling wiring in place and ready for connection.
Step 1 – Remove the speaker grille:
The grille must be
removed for access to the mounting screws. Insert a pointy
object and introduce it in a grille hole close to the edge. You’ll
remove the grille with ease if using two pointy objects on
opposite ends.
WARNING:
BE CAREFUL NOT TO DAMAGE THE CONE WITH
THE POINTY OBJECT WHEN REMOVING THE GRILLE
Step 2 – Ceiling tile cut out:
The following table lists the
inner and recommended cut out diameters for the different
models and the necessary depth in the ceiling structure to
install the speakers:
Table 1: inner and cut out diameters
Packaged with the speakers is a cardboard cut out template
for scribing the cut out hole onto your ceiling surface. The
inside circumference of the same template can be used to
cover the rest of the speaker when painting.
Therefore the cut out may be scribed using the template
provided or by drawing a circumference of the diameter in
table 1. Once the hole is cut, you may need to pull down the
cables so they are accessible for connection.
Fig. 6 – circular cut out, installation wiring
Step 3 – Terminal connection:
the speakers terminals are
spring loaded. Watch the colour coding for polarity. For
connection to transformer models, you will need to select the
required input power and connect to the appropriate terminals
(see Fig. 7).
Fig. 7 – CL-5T; input power selection terminals
Step 4 – Inserting the speaker
: follow these steps:
•
Hold the speaker in one hand, while you use the other
hand to connect the cable to the speaker.
•
Push the assembly all the way into hole. The four
mounting tabs must be tangential to the ring, otherwise
they’ll be in the way.
Fig. 8 – terminal connection; speaker positioning
WARNING:
ALWAYS HOLD THE SPEAKER BY THE PLASTIC
SUPPORT, AVOIDING DAMAGE TO THE TRANSDUCER
DIAPHRAGMS
MODEL Depth INNER
DIAMETRE
CUT OUT
DIAMETRE
CL-5, CL-5T
70mm
165 mm (6.6 in) 166 mm (6.65 in)
CL-6, CL-6T
80mm
193 mm (7.7 in) 194 mm (7.76 in)
CL-8, CL-8T
97mm
237 mm (9.5 in) 238 mm (9.52 in)
CL-6TB
160mm
198mm (7.8 in)
202mm (7.9 in)
