EN / CZone Touch 10 Generation 2 User & Installation Manual
10
3.3
Mounting Instructions
Follow the below steps for mounting the Touch 10 to the chosen mounting surface
Figure 4. Mounting Exploded View
1. Place supplied cutout template on mounting wall using adhesive tape (note: maximum wall
thickness = 25mm)
2. Use a 10mm drill bit to cut four corner holes
3. Cut along dotted line and remove inner section
4. Remove the VHB tape liner from back of the plastic mounting bracket and take note of the
TOP and BOTTOM labels
5. Insert plastic mounting bracket in to mounting hole but do not stick to mounting wall yet
6. Hold metal backing frame behind mounting wall cutout and secure to bracket using the
supplied screwdriver and 14 screws (note: two screw sets are supplied. Use short screws for
walls 15mm or less and long screws for walls up to 25mm)
7. Once all screws are tightened, press bracket down firmly to ensure bracket bonds to wall with
the VHB tape
8. Insert Touch 10 into mounting bracket by hooking top of panel into bracket and pressing
bottom of display until it clips firmly in to place
9. To remove Touch 10 from bracket, carefully insert flathead screwdriver into slot at bottom of
display and twist until it unclips
Metal Backing
Frame
Mounting surface
Plastic Mounting Bracket
Mounting Screws
Display
