EN / CZone® Control 1
8
10. USB Programing Button & Status LED
11. USB Port
12. Spare Fuse Positions
13. Dipswitch
14. Fuse Picker
15. Fault Code/Input Label
16. NMEA 2000 Connector (5-pin)
17. Analogue Input Connector
CONTROL 1 OVERVIEW
Figure 1. Control 1 with Cover
Figure 2. Control 1 without Cover
3 4 5 6 7 8
__________________
Channel LED Flash Codes
GRN solid on = Channel on
1 x RED = Module not configured
2 x RED = Configuration conflict
3 x RED = Dip switch conflict
5 x RED = No modules detected
7 x RED = Fuse blown
9 x RED = Missing commander
OUT-H (1-4)
NMEA
OUT-L (5-16)
IN-A (1-8)
Manual Fuse Bypass
INSERTING FUSE CREATES
IGNITION HAZARD, ENSURE
AREA IS FREE OF
EXPLOSIVE GASES
BYPASS
NORMAL
FU
S
E
THIS DEVICE IS IGNITION
PROTECTED ONLY WHEN CLEAR
COVER IS FITTED AND LATCHED
ISO8846 / SAE J1171 TESTED
WARNING
1 _______________________
2 _______________________
3 _______________________
4 _______________________
5 ________________________
6 ________________________
7 ________________________
8 ________________________
Analogue Inputs (IN-A)
1
DIP
ID
2
www.czone.net
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Green - Power
Red Flash - Traffic
NETWORK
STATUS
Green - Available
Red - Low Volts
CONTROL 1
POWER
1
2
9
10
11
12
13
14
15
16
4
5
6
2
7
8
17
1. Top Cover
2. Clips for Top Cover Removal
3. Circuit Label
4. Circuit Fuses
5. Main Positive Stud
6. Low Current Output Connector
7. Negative Stud
8. High Current Output Connector
9. Circuit Status Indicator Label
3
