41
Cytavision installation guide • chapter 4 - remote control
4.2.1
Manual Brand search
In order to manually introduce the TV code, you must
follow these steps:
1. To begin the procedure your TV must be switched on.
2. Press and hold the digits “1” and “3”
simultaneously for a minimum of 3 seconds.
3. After 3 seconds, the TV LED on the remote control
will turn on. Release the keys.
4. Now enter the 4-digit code for the appropriate TV
brand (please refer to APPENDIX A). When a digit is
pressed, the TV LED gives a short inverse blink and
after the fourth digit is entered, the remote checks if
the 4-digit code is valid.
5. If correct, the TV LED will do a confirmation blink
and remain switched on. If the code is not valid, the
remote control will execute an error-blink and return
to normal operation mode.
6. Then hold the Power or Mute key; after 2 seconds,
the TV LED will blink during transmission of the code. If
the TV is turned off or goes mute depending on which
button was pressed for 2 seconds, it means that the
right code was transmitted.
7. When the right code is transmitted, release the
Power or Mute button and normally the TV will be
turned off or go mute respectively to indicate that the
correct code was transmitted.
8. Press HOME and STOP key simultaneously to save
your set up after getting the correct codes.
4.2.2
Auto Search
If you are not able to find the proper code for a
particular brand of equipment listed, or none of the
listed codes for that brand seem to work, please
perform an auto code search of the entire code
database for that mode.
In order to introduce the TV code, you must follow
these steps:
1. To begin the procedure your TV must be switched
on.
2. Press and hold the digits “1” and “3” simultaneously
for a minimum of 3 seconds.
3. After 3 seconds the TV LED of the remote control of
STB will turn on. Release the keys.
4. Now press the digits “0000” for auto search.
5. If correct, the TV LED will do a confirmation blink and
remain on.
If the code is not valid, the remote control of STB will
perform an error-blink and return to normal operation
mode.
6. Then press and hold the Power or Mute key; after 2
seconds the remote control will start auto-search. You
must keep holding the button until the TV reacts. The
TV LED will blink during transmission of the code. This
operation may take a while as the remote control is
searching through hundreds of different TV brands.
7. If you press the Power key, when finding the right
code, the TV will turn down to indicate that the correct
code is found. If you press the Mute button, when
coming across the right code, the TV will be muted to
indicate that the correct code is found. After accessing
the right code, release the Power or Mute button.
