Cyrus i9-XR
User Instructions
19
Checking programmed commands
• Select the mode that you just programmed and check
that the commands were learned successfully.
NOTE: The TV or SAT mode key should flash red when
sending a command. If the mode key is not flashing, then
the command has not learned correctly.
• Make a note of any commands that have not
programmed correctly and repeat the learning process
to add these in.
NOTE: When you start the learning process it does not
erase any programmed keys so you can re-program
individual keys if required.
Problems with learning
If none of the commands have learned correctly, try re-
starting the learning process again. Test a few keys first
to ensure that your handset is compatible for learning. If
the test works then continue to program the rest of the
commands you need.
If you still have problems, check carefully that the mode
light is flashing correctly as you send a command to learn.
If not, it may be that the batteries need replacement in
the reference handset or that the spacing between the
handsets is not ideal. Try adjusting the spacing between
the handsets and repeating the learning process.
If you continue to have problems, it may be that your
handset is incompatible with the learning process. This
could happen with an older design of handset or one that
has an unusual code-set.
Sending TV or SAT commands
Once you have programmed all the keys with the
commands you want, you can use the remote control to
send commands to your TV or Satellite receiver etc.
• Press the TV or SAT key to select the mode you want.
• Press the command key.
The mode key will flash red when sending a programmed
command.
