PSoC® 6 BLE Prototyping Board Guide, Doc. # 002-24993 Rev. **
5
Safety and Regulatory Compliance
Information
The CY8CPROTO-063-BLE PSoC 6 BLE Prototyping Board is intended for use as a development
platform for hardware or software in a laboratory environment. The board is an open system design,
which does not include a shielded enclosure. This may cause interference to other electrical or
electronic devices in close proximity. In a domestic environment, this product may cause radio
interference. In such cases, you may be required to take adequate preventive measures. In addition,
this board should not be used near any medical equipment or RF devices.
Attaching additional wiring to this product or modifying the product operation from the factory default
settings may affect its performance and cause interference with other apparatus in the immediate
vicinity. If such interference is detected, suitable mitigating measures should be taken.
The CY8CPROTO-063-BLE PSoC 6 BLE Prototyping Board contains
electrostatic discharge (ESD) sensitive devices. Electrostatic charges
readily accumulate on the human body and any equipment, and can
discharge without detection. Permanent damage may occur on
devices subjected to high-energy discharges. Proper ESD precautions
are recommended to avoid performance degradation or loss of
functionality. Store unused CY8CPROTO-063-BLE PSoC 6 BLE
Prototyping Board Kit boards in the protective shipping package.
End-of-Life/Product Recycling
This kit has an end-of-life that is five years from the date of
manufacture mentioned on the back of the package. Contact your
nearest recycler for discarding the kit.
