PSoC™ 6 Wi-Fi Bluetooth® pioneer kit guide, Document Number. 002-22677 Rev. *I
12
Introduction
Table 1-1. Pioneer board pinout
PSoC™ 6
pin
Primary
on-board function
Secondary
on-board function
Connection details
XRES
Reset
–
P0.0
WCO IN
–
P0.1
WCO OUT
–
P0.2
Header compatible with
Arduino J4.8, D7
–
P0.3
RGB LED (red)
–
P0.4
User button with Hiber-
nate wakeup capability
–
P0.5
PMIC control
–
P1.0
CAPSENSE™ Tx
GPIO on
non-Arduino header
(J19.5)
Populate R174 to connect to the header or
remove R62 to disconnect from CAPSENSE™.
P1.1
RGB LED (green)
–
P1.2
GPIO on non-Arduino
header (J19.4)
–
P1.3
GPIO on non-Arduino
header (J19.3)
–
P1.4
GPIO on non-Arduino
header (J19.2)
–
P1.5
User LED (orange)
GPIO on
non-Arduino header
(J19.1)
Connected to primary and secondary functions
by default. Remove R27 to disconnect from the
LED.
P2.0
SDIO DATA0
J25.7
(WL_JTAG_TMS)
Remove R122 (or R110) and mount R115 to
disconnect from PSoC™ 6 MCU and connect
the Wi-Fi/Bluetooth
®
module to the JTAG
connector.
P2.1
SDIO DATA1
J25.3
(WL_JTAG_TDI)
Remove R32 (or R111) and mount R116 to
disconnect from PSoC™ 6 MCU and connect
the Wi-Fi/Bluetooth
®
module to the JTAG
connector.
P2.2
SDIO DATA2
J25.5
(WL_JTAG_TDO)
Remove R128 (or R112) and mount R117 to
disconnect from PSoC™ 6 MCU and connect
the Wi-Fi/Bluetooth
®
module to the JTAG
connector.
P2.3
SDIO DATA3
J25.1
(WL_JTAG_TRSTN)
Remove R109 (or R132) and mount R114 to
disconnect from PSoC™ 6 MCU and connect
the Wi-Fi/Bluetooth
®
module to the JTAG
connector.
P2.4
SDIO CMD
–
P2.5
SDIO CLK
J25.9
(WL_JTAG_TCK)
Remove R108 (or R28) and mount R113 to
disconnect from PSoC™ 6 MCU and connect
the Wi-Fi/Bluetooth
®
module to the JTAG
connector.
